TP-017 WARRIOR® StarterTattoo Tattoo Pen - Exclusive for Tattoo Beginners

Instruction manual

Operating mode

Normal Mode:

• Press and hold the Power button to turn the device on/off. After turning on, the screen lights up. Quickly press the power button to start the engine. At the same time, the screen shows "xxxx", and when the button is pressed, the buzzer beeps.

Forced Start Mode:

• In power off mode, quickly press the power button twice to turn on the machine. Then, briefly press the Power button to enter the forced boot mode. After starting with a maximum voltage of 12V for 0.5 seconds, the machine turns on and the voltage set on the screen is restored.

Operating Instructions

1. Working Mode:
   • Press the power button to start/stop the machine. The timing function will also start/stop.
   • The screen automatically dims after 10 seconds and the device automatically turns off after 5 minutes of inactivity.
   • Quickly press the "+" or "-" buttons to increase/decrease the voltage by 0.1V. The screen will display the current voltage value. Adjust the tension according to the tattoo requirements and your experience.
   • Press and hold the "+" or "-" buttons to quickly increase/decrease the voltage. The screen will display the current voltage value.
   • In forced start mode, if the power is disconnected while working and then reconnected, you will experience a forced start of 0.5 seconds before returning to the designated operating voltage.

Safety Precautions

1. Do not use the tattoo pen while charging.
2. Make sure your tattoo pen is fully charged and has enough battery to complete the job.
3. Before use, clean and sterilize instruments following hygiene standards to ensure safety.
4. Adhere to hygiene standards and correct procedures when using the tattoo pen.
5. When not in use, store your tattoo pen in a safe place, out of reach of children.
6. Avoid submerging the tattoo pen in water or exposing it to liquids to prevent damage to electronic components.
7. If you have any questions or need further assistance, please refer to the after-sales service contact information. We will do our best to respond to your requests.

Specifications

• Mechanism: Non-removable battery
• Material: Aluminium
• Battery Type: 1500mAh rechargeable lithium polymer battery
• Motor: 8V 8500rpm flat motor
• Operating Voltage: 4.5-12V (it is recommended not to exceed 10V)
• Stroke: 4.2mm
• Charging Time: 3-4 hours for a full charge
• Operating Time: 4-5 hours
• Battery Safety: Microchip battery controller that prevents short circuits, overcharging, overcurrent or discharge of the battery.
• Warranty: 1 year

Display Codes

• E1: When the motor experiences a jam or short circuit during operation, E1 code appears on the screen. The buzzer emits 2 alarm beeps. After a 2 second delay, normal operation can resume. If no action is taken, the screen dims after 10 seconds and the device turns off after 5 minutes. Upon restarting, if an engine jam is detected again, the E1 code appears again.
• E2: When the output reaches 700mA (simulated electronic load test), the Over Current Protection (OCP) activates. The power output is turned off and the screen displays the code E2. The buzzer emits a repeated beep as a warning signal.

Display Diagram

• Power Button
• Timer
• Voltage display
• Normal mode
• Forced Start Mode
• Battery Capacity
• Work in progress
• "+" button
• Button "-"

If you have additional questions or need further assistance, please contact the customer service provided by the manufacturer.